Incest In Brazil Is Legal

MOUNTING SYSTEM

For self-assembly RO system will need the following tools:

first Drill
second Drill Ø 4, Ø 6 Ø 10, Ø 13
third Teflon tape
4th Screwdriver, Phillips,
5th Pliers
6th Scissors or a knife
7th for wallpapers Wrenches 17, 24, 32 or key główkowy extending straight,

to connect the power supply RO system, make sure where it is fed into the cold water tap water, and here we have two possibilities: first
coming out from the wall faucet - must turn off the main water supply valve, unscrew the taps in the tap to drain the water, when I unscrew the batteries no longer fly on the wall / flat key 32 / and screw in extensions / should be noted that the Extension of the pinhole was screwed onto the water outlet COLD, then screw in the battery. For the pinhole in przedłużce screw in ball valve which is being equipped with the system it will be deduced bakelite tube through which the system will be supplied with cold water.
second Faucet mounted on the sink - the sink locates the tubing through which water is fed to the tap, check that is with cold water. If you have localized the valve in the wall to which it is connected to cold water, turn it off so we cut off the cold water tap in the tap open the valve to drain the trapped water. Once the cold water tap not fly, we proceed to unscrewed the hose from the valve protruding from the wall / COLD WATER. Perhaps it will be ½''or 3 / 8''in its place came the screw in the extension system with a hole for the screw in the ball valve which is being equipped with the system it will be deduced bakelite tube through which the system will be supplied with cold water.
looking for a place on the faucet / section 4 / schema drill two holes next to each other at a distance corresponding to two threaded pipe and mount the faucet spout.
If the item is over it while under the sink cabinet bracket assume the sink drain pipe and a threaded hole drill hole drill Ø4. Then put
contributions to the housing 10''according to the scheme / Operating principles / hose and connect the cold water supply system in the entrance of No. 2 1dokolanka connect the hose to vent the pre-treatment / cartridges A, B, C. When you disconnect the hose odpowietrzymy which water flowed from the air and return to its original condition.
the valve weir / Item 8 / schema connect the hose and the other end of the mount bracket in the sink drain / Item 9 / schema - that way will be rejected in the dirty water that contains contaminants that are not passed through the osmotic membrane. Connect the hose again to the tee with a linear filter / Item 7 / schema, the other end put the ball at the tank zaworku / Item 6 / schema; the tee, the filter line / paragraph 15 of schedule / conduct the hose to the water spout which is passed only through a linear filter, while mineralized water is carried from the elbow / Item 14 / schema to the spout.